CHAdeMO: DC charging over CAN
The Japanese DC standard: 11 bit CAN frames every 100 ms between car and charger, next to analogue start, stop and permission lines.
Frames
| CAN ID | Sender | Content |
|---|---|---|
| 0x100 | Car | Battery limits: maximum voltage, charged rate reference |
| 0x101 | Car | Maximum and estimated charging time, battery capacity |
| 0x102 | Car | Protocol version, target voltage, current request, status and fault flags, state of charge |
| 0x108 | Charger | Available voltage and current, threshold voltage, welding detection support |
| 0x109 | Charger | Protocol version, present voltage and current, remaining time, status and fault flags |
Both sides send every 100 ms. The bus runs at 500 kbit/s. Frames 0x110 to 0x209 carry the dynamic control and bidirectional extensions of later versions.
CHAdeMO is not published openly. The byte offsets come from secondary sources and are marked for verification in the module's field table.
Sequence
- The car and charger exchange limits (0x100, 0x108) and check compatibility.
- The charger locks the connector and runs the insulation test.
- The car closes its contactors; the charger starts delivering current and follows the current request in 0x102.
- Either side ends by clearing its charging flag; the charger ramps down, checks for welding and unlocks.
CH-01 to CH-06 check the version agreement, that output stays inside the car's request and limits, the fault flags and the stop sequence. CAN-01 and CAN-02 check that the bus does not fall silent and that each cyclic frame keeps its period.
Sources
- CHAdeMO protocol as implemented by the analyzer's field table, offsets marked for verification