ChaoJi and CHAdeMO 3.0

The joint successor of CHAdeMO and the 2015 GB/T DC system, developed by China and Japan: a smaller connector for higher power, CAN communication in the tradition of both systems, and adapters for backward compatibility.

Origin

By the late 2010s both CHAdeMO and the GB/T DC system (GB/T 20234.3 and GB/T 27930, 2015 editions) were reaching the limits of their connectors. The China Electricity Council and the CHAdeMO Association agreed to develop a common next generation system instead of two separate ones. The result is known as ChaoJi. Japan publishes it as CHAdeMO 3.0; China publishes it in its national GB/T standards.

The dates of the agreement (commonly given as 2018 to 2019), of CHAdeMO 3.0 (2020) and of the Chinese standards (2023 editions), and the GB/T part numbers, are to be verified.

What changes and what stays

AspectCHAdeMO 1.x / 2.x and GB/T 2015ChaoJi
ConnectorLarge connectors, locking on the connector sideSmaller connector, locking moved to the vehicle inlet, designed for liquid cooled cables
PowerUp to a few hundred kWDesigned for much higher power, with voltages up to the 1500 V class
CommunicationCAN (CHAdeMO at 500 kbit/s, GB/T with J1939 addressing)CAN, based on the existing CHAdeMO and GB/T message sets with extensions
Safety conceptSeparate analogue lines and insulation checks per systemRevised control and detection circuits, common to both variants
BidirectionalCHAdeMO V2H and V2G in 2.xPlanned in the design

The rated voltage and current (figures such as 1500 V and 600 A are often quoted) are design targets from announcements and are to be verified against CHAdeMO 3.0 and the GB/T texts.

Backward compatibility through adapters

A ChaoJi car cannot plug into an older charger directly, because the connectors differ. The plan is that the car side inlet is new and that adapters let a ChaoJi car use existing CHAdeMO or GB/T chargers, since the communication on both sides of the adapter is CAN based and closely related. Adapters to CCS chargers have also been discussed; these would need an active adapter that translates between powerline and CAN.

  • A passive adapter can map contacts but not protocols: it works where the old and new systems speak compatible CAN messages.
  • An active adapter contains its own controller and speaks two protocols, one per side. A capture on either side then shows a different conversation, and a fault may lie in the adapter.
  • When testing through any adapter, record which adapter and firmware were used; it belongs in the test report as much as the car and charger.

Which adapters are standardised, and whether they are passive or active for each combination, is to be verified.

In this tool

The tool reads CHAdeMO up to the version in its field table and GB/T 27930 in its 2015 form. ChaoJi sessions are not decoded yet. A CAN log of a ChaoJi session will still load, and the CAN-01 and CAN-02 checks on bus activity and cyclic periods still apply, but the protocol module may not recognise the messages or may decode them with the older layout. Treat any decoded values from a ChaoJi log with caution until a ChaoJi module is added to the registry.

Sources

  • CHAdeMO 3.0, CHAdeMO Association
  • GB/T 20234.4 and GB/T 27930-2023, Chinese ChaoJi coupler and communication, see verify notes
  • China Electricity Council and CHAdeMO Association, joint ChaoJi development