GB/T 27930: the Chinese DC protocol
DC charging communication between battery management system (BMS) and charger over CAN with SAE J1939 addressing, in four phases.
Phases and messages
| Phase | Charger sends | BMS sends |
|---|---|---|
| Handshake | CHM (version), CRM (recognition) | BHM (maximum voltage), BRM (battery identity, multi packet) |
| Parameter configuration | CTS (time), CML (output limits), CRO (ready) | BCP (charging parameters, multi packet), BRO (ready) |
| Charging | CCS (output voltage, current, time) | BCL (demand), BCS (measured, SOC), BSM (battery state) |
| End | CST (stop reason), CSD (statistics) | BST (stop reason), BSD (statistics) |
| Errors | CEM (timeout report) | BEM (timeout report) |
Each step has a timeout; a side that does not hear the expected message reports it with BEM or CEM. GB-01 to GB-07 check the handshake steps and their timing, that output stays within demand and limits, and the stop reasons.
The field offsets follow the 2015 edition as published by secondary sources and are marked for verification. The 2023 edition (ChaoJi) is not covered yet.
Scaling to watch for
Currents are sent with an offset of -400 A at 0.1 A per bit, so a raw value of 4000 means 0 A and lower values mean charging current. Values of 0xFF, 0xFFFF and above 0xFE00 mean not available or error in J1939, and the decoder treats them that way instead of reading 6553.5 V.
Sources
- GB/T 27930-2015