MCS: the Megawatt Charging System
A DC charging system for trucks, buses and other heavy vehicles with currents in the thousands of amperes. It keeps the ISO 15118-20 application layer but uses a new connector, a different signalling scheme instead of the Control Pilot, and single pair Ethernet instead of powerline.
Who writes it
- CharIN drove the requirements and the connector design with truck and charger makers, and published its own MCS specification.
- IEC standardises the vehicle coupler (IEC TS 63379) and the station requirements (in the IEC 61851-23 family).
- SAE publishes J3271 for North America, covering the system from the vehicle side.
- ISO 15118-10 defines the single pair Ethernet link; ISO 15118-20 the messages.
The exact document types (Technical Specification versus International Standard) and their publication dates move quickly. Verify them before citing.
Ratings
| Item | Value quoted for MCS |
|---|---|
| Maximum current | up to 3000 A |
| Maximum voltage | 1250 V class |
| Maximum power | up to about 3.75 MW (3000 A at 1250 V) |
| Cooling | Liquid cooled cable and connector with temperature monitoring |
| Inlet position | Standardised position and approach zone on the vehicle so a robot or driver can connect it |
The 3000 A and 1250 V figures are the widely quoted design targets. The current and voltage classes actually standardised, and what chargers deliver in practice (often much less), are to be verified.
Signalling without the Control Pilot
The powerline on the Control Pilot is limited in bandwidth and robustness, and a megawatt cable is an electrically noisy place. MCS therefore separates the functions. Instead of one CP wire carrying both the analogue states and the powerline signal, the connector has dedicated signal contacts: a pair for the data link and separate contacts for the analogue signals that tell car and charger that the connector is inserted and that charging may proceed.
| Function | CCS | MCS |
|---|---|---|
| Plug present and cable rating | PP resistor | A dedicated identification and presence signal |
| Ready and permission | CP states B and C by car resistor | A dedicated charge enable signal with its own states |
| Data | HomePlug Green PHY on CP | 10BASE-T1S on a dedicated pair (ISO 15118-10) |
| Pairing | SLAC | Not needed: a point to point Ethernet link cannot reach a neighbouring charger |
| Application | DIN SPEC 70121, ISO 15118-2, ISO 15118-20 | ISO 15118-20 only |
The signal contact names (commonly given as CE for charge enable and ID for identification) and their voltage states are to be verified against the CharIN specification and IEC TS 63379.
In this tool
An MCS capture taken on the 10BASE-T1S pair (with a T1S capable network tap that records Ethernet frames) carries IPv6, SDP, TCP, TLS 1.3 and ISO 15118-20 exactly as on a CCS cable, so the ISO 15118-20 module, the TLS checks and the IS20 checks apply. The SLAC and CP layers stay empty because they do not exist. Limits that depend on power (such as the charger at or below its limits in IS20-03) take their values from the messages, so they work at megawatt scale without change.
Check the timing limits in the profile before judging an MCS session: the heavy vehicle use cases may define their own timeouts in the MCS documents.
Sources
- CharIN Megawatt Charging System specification
- IEC TS 63379, vehicle coupler for megawatt charging
- SAE J3271, megawatt charging system for heavy vehicles
- ISO 15118-10, single pair Ethernet physical and data link layer
- ISO 15118-20:2022, application layer