Japan: CHAdeMO, Type 1 and the 300,000 port target

Japan is the home of CHAdeMO: DC charging over CAN, standardized internationally in IEC 61851-23, IEC 61851-24 and IEC 62196-3, with bidirectional use since 2012. AC charging uses the Type 1 connector. METI aims at 300,000 charging ports by 2030; about 68,000 were in place in March 2025.

At a glance

AspectJapan
AC connectorType 1 (SAE J1772, IEC 62196-2 Type 1), single phase
DC connectorCHAdeMO (IEC 62196-3); NACS announced by Sony Honda Mobility and Mazda for future models
Car to charger communicationCAN, CHAdeMO protocol (IEC 61851-24 annex, JIS D 61851-24:2014); CHAdeMO 3.0 is the Japanese side of ChaoJi
BackendOCPP, offered for example by e-Mobility Power for rapid chargers it manages
Key rules and plansMETI charging infrastructure guideline (October 2023): 300,000 ports by 2030; special metering system from 1 April 2022 opens kWh billing
Test and certificationCHAdeMO certification by bodies registered with the CHAdeMO Association; JIS and JEVS standards from JSA and JARI

CHAdeMO and its versions

The CHAdeMO Association was set up in March 2010; its membership grew from 158 at the start to 429 in March 2012, according to the association. It writes the protocol, runs its certification and co-develops ChaoJi with the China Electricity Council. CHAdeMO: DC charging over CAN describes the frames on the bus.

VersionWhat it brought
0.9The first published protocol (2010), up to 62.5 kW (125 A at 500 V)
1.0, 1.1Refinements for protection, compatibility and reliability (1.0 in 2012); 1.1 (2015) added dynamic current control
1.2Up to 200 kW, 2017
2.0Up to 400 kW and 1 kV with liquid cooled cables, published in 2018
3.0The CHAdeMO side of ChaoJi: released to regular members on 24 April 2020, a plug identical to the Chinese ChaoJi plug, up to 600 A

Minor versions exist in the field: e-Mobility Power announced that its 350 kW charger received CHAdeMO 2.0.2 certification on 27 March 2025.

The years follow the protocol development page of the CHAdeMO Association. The specification itself is not public, so what each version brought is taken from the association's own summaries.

Standards: IEC, JIS and JEVS

  • Japan's DC proposals became the basis of IEC 61851-23 (DC charging stations), IEC 61851-24 (the digital communication for DC charging control) and IEC 62196-3 (DC couplers), as the CHAdeMO Association described in 2014.
  • The Japanese Standards Association publishes them as JIS D 61851-23:2014 and JIS D 61851-24:2014.
  • The Japan Automobile Research Institute (JARI) publishes the JEVS vehicle standards. JEVS G 105 covers the rapid charging connector (the Nissan and Nichicon V2H unit of 2012 names it for its connector), and JEVS G 101 and G 103 cover rapid charging systems.
  • For AC, nearly every EV sold in Japan has a Type 1 inlet. SAE J1772: the North American coupler and pilot and IEC 62196: plugs, sockets, connectors and inlets describe the connector; in Japan it is used on single phase supplies.

The Japanese rating of the Type 1 coupler (often quoted as 250 V and 32 A single phase) comes from a secondary source and is to be checked against the JIS and JEVS texts.

Targets and counts

The Ministry of Economy, Trade and Industry (METI) published its guideline for promoting charging infrastructure in October 2023. It doubles the earlier target of 150,000 to 300,000 ports by 2030: 270,000 normal chargers and 30,000 public rapid chargers. It also aims to double the average rapid charger output to 80 kW and to reach a total installed output of about 4 GW, ten times the level at the time.

CountValueDate and source
All portsabout 68,000March 2025, METI
Normal portsabout 56,000 (about 25,000 at homes and workplaces, 31,000 at destinations)March 2025, METI
Rapid portsabout 12,000March 2025, METI
Chargers bought with national subsidies, 2009 to 202514,507 rapid and 111,359 normale-Mobility Power, April 2026
e-Mobility Power rapid network454 expressway sites (1,066 ports) and 1,677 general road sites (2,460 ports)end of March 2026, e-Mobility Power

The yearly report of e-Mobility Power covers its rapid chargers at expressway service and parking areas and on general roads; it does not count the chargers of other networks.

Higher power and billing by kWh

  • From fiscal 2024, e-Mobility Power installs rapid chargers of at least 90 kW per port in principle, and at sites with four or more ports at least one port of up to 150 kW. It reported in April 2026 that ports below 50 kW fell by 1,377 during fiscal 2025 while ports of 90 kW and more grew by 1,050.
  • With Takaoka Toko it developed a CHAdeMO charger of up to 350 kW per port and 400 kW for two ports (400 A, 1000 V), announced in May 2024 for installation from autumn 2025.
  • Selling charging by the kWh needed meters approved under the Measurement Act. The special metering system created by the 2020 amendment of the Electricity Business Act, in force from 1 April 2022, lets the metering function inside a charger be used for trade under set rules.
  • METI aimed at kWh billing from fiscal 2025. e-Mobility Power announced kWh billing at 96 of its own rapid sites from 1 April 2026, at 143 yen per kWh on expressways and 110 yen on general roads.
  • Fire safety: after a study of rapid charging equipment above 50 kW in fiscal 2019, the Fire and Disaster Management Agency amended the ministerial ordinance that sets the standards for local fire prevention ordinances. From 1 April 2021 its rules for rapid charging equipment cover outputs up to 200 kW instead of 50 kW, with added fire prevention measures.

The detailed measures of the amended ordinance, how each local fire prevention ordinance applies them, and the rules for equipment above 200 kW were not checked for this page.

Vehicle to home: where CHAdeMO went first

Bidirectional DC charging reached homes in Japan years before other regions. The CHAdeMO Association started a working group on a V2H extension in October 2011. Nissan and Nichicon presented "LEAF to Home" in May 2012: the Nichicon EV Power Station connects to the LEAF's rapid charging port, follows the CHAdeMO protocol and a JEVS G 105 connector, and feeds the house from the car's 24 kWh battery. Nissan showed it in Japanese dealerships from June 2012.

An initial CHAdeMO V2X guideline dates from 2012 and was published after further work in 2014, according to the association. Because the DC converter sits in the wall box, the car only has to allow current in both directions over its CHAdeMO inlet. Bidirectional charging: V2G, V2H, V2L compares this with ISO 15118-20.

Certification, backend and the NACS question

  • CHAdeMO runs its own third party certification of chargers and cars. The association lists registered certification bodies, including Applus+ IDIADA (Spain, the first in Europe), Intertek Japan, TERTEC (Taiwan), TUV Rheinland Japan and UL Japan; DEKRA certifies CHAdeMO in the Netherlands.
  • OCPP is in use between chargers and operators: e-Mobility Power offers a management service for OCPP compatible rapid chargers, and the Open Charge Alliance held its first meet up in Japan on 2 June 2026.
  • Sony Honda Mobility announced on 27 September 2024 that its AFEELA cars adopt NACS (SAE J3400), first in the United States and later in Japan. Mazda announced in May 2025 that its EVs for Japan get NACS ports from 2027, with adapters for other standards. SAE J3400: the NACS coupler describes the connector.

The list of CHAdeMO certification bodies changes; check the association's current register before choosing a laboratory.

In this tool

  • The analyzer reads CHAdeMO sessions from CAN frames in a pcap. The chademo demo is a complete session; chademo-stop shows a charger that sets its malfunction flag after 12 s.
  • CH-01 to CH-06 check the version agreement, output against the car's request and limits, the fault flags and the stop sequence; CAN-01 and CAN-02 watch the bus timing.
  • The control protocol number of each side reads as a CHAdeMO version (1 as 0.9, 2 as 1.0, 3 as 1.1 or 1.2, higher as 2.0 or later). These readings are marked for verification, and frames new in CHAdeMO 3.0 decode as unknown.

Sources